FlowPrep 060

FlowPrep 060 lets you choose the temperature, gas, and flow rate best suited for your sample material and application.

Specification

Sample Tubes

Up to 3.0-cm (1.18-in.) OD

Heating Block

Temperature: 10 ºC above ambient to 400 ºC
Temperature Accuracy: ± 10 ºC

Electrical

Voltage: 100, 120, 220, 240 VAC ± 10%
Power: 250 VA maximum
Frequency: 50/60 Hz

Environment

Temperature: 10 to 35 ºC operating; 0 to50 ºC non-operating
Humidity: 45 to 80% relative, non-condensing

Gases Used

Helium, nitrogen, argon, or any other pure gas that does not adsorb at room temperature

Flow Rate

Up to 50 cm3/min. No vacuum required

Sample Capacity

6 heating stations and 6 cooling stations

Physical

Height: 45 cm (16.93 in.)
Width: 36 cm (14.17 in.)
Depth: 30 cm (11.81 in.)
Weight: 8.6 kg (19 lbs)

Overview

The FlowPrep™ 060 applies both heat and a stream of inert gas to the sample. The heat causes contaminants to desorb from the surface and the stream of inert gas sweeps them out of the sample tube. It lets you choose the temperature, gas, and flow rate best suited for your sample material and application. Needle valves allow you to introduce the flowing gas slowly to prevent fluidization of samples.